Security IE minilab hints:

Step 2:

What does inverse-arp on Frame Relay do?

Step 3:

The commands on this Cat 1200 are a little bit different than the Catalyst 5000. The ip address for VLAN 400 is not assigned to the sc0 interface on this device. Check out the following link for configuration information on the Cat1200.

http://www.cisco.com/univercd/cc/td/doc/product/lan/catalyst/cat12icg/62312.htm

Step 4:
A Static NAT translation may be required to complete this step

Step 5:
Do you need to create a more granular dialer-list?

Step 6:

What type of things do you need to worry about when configuring a routing protocol over a NBMA topology?

Step 7:

Can the PIX advertise routes via RIP? If so, what type of routes?

Step 8:

Looks like you have a discontigous EIGRP autonomous system. How would you tie it together?