|
Author
|
Topic: ASA Active/Standby
|
liban
Specialist
Member # 24092
Rate Member
|
posted October 24, 2011 08:21 AM
Do we need the "failover lan enable" command on the primary and secondary devices while configuring Active/Standby failover on ASA ?
Because I do my labs on PIX and found out that the failover doesnt begin without this command.Any comments ???????
Posts: 83 | From: india | Registered: Dec 2007
| IP: Logged
|
|
Smeans
unregistered
|
posted October 24, 2011 08:31 AM
No, to activate the failover pair on an ASA pair(after you've done the rest of your config), you simply need to type the "failover" command.
Failover lan enable is a pix thing, because you can also do the non-lan (serial cable) version of the config.
IP: Logged
|
|
|
UBBFriend: Email this page to someone!
Printer-friendly view of this topic